Vaillant geoTHERM SERIES Manuale di Installazione Pagina 14

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 92
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 13
Installation instructions geoTHERM VWS/VWW 0020057444_0114
300 mm
10 mm
600 mm
300 mm
300 mm
Fig. 4.2 Minimum clearances for installing the heat pump
4.4 Assembly/Installation at a glance
– Remove packing material.
Remove transportation safety devices.
Transport the heat pump to the installation area.
Position and align the heat pump in the intended as-
sembly location.
Remove the upper cladding.
Remove the front cladding.
Connect the on-site piping.
Carry out the electrical installation.
Fill the heating circuit.
Fill the heat source circuit.
– Fit the cladding.
Fit the operating console.
Carry out the initial commissioning.
Fill out the start-up checklist.
Hand over system to the user and familiarise him with
it.
4.5 Preparatory work in the installation area
1
1
2
3
3
Fig. 4.3 Preparatory work in the installation area
Make sure that the substrate is sufficiently stable (see
Chap. 4.2 "Requirements for the installation site").
Make at least two bore holes, bearing in mind the di-
mensions of the unit and its connections (1).
Each pipe from the heat source requires its own bore
hole.
Special pipe feedthroughs must be used if there is a
risk of ground water penetration (follow the manufac-
turer's instructions).
Take account of the distances to the core barrels for
the rest of the installation.
Pass the heat source pipes (2) from the outside into
the installation area.
Lay the heat source pipes (2) centrally in the bore
holes (1) to facilitate all-round thermal insulation.
Seal the annular gap (1) as shown with foam insulation
(e.g. PE foam) (3).
Insulate the heat source pipes in cellar areas against
vapour diffusion, as condensation will otherwise accu-
mulate (pipe temperature can be as low as - 15 °C).
4 Assembly and installation
Vedere la pagina 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 91 92

Commenti su questo manuale

Nessun commento